Speed Dial on 8831 with a pause

[Ed Kender]

Good Morning - we are running CUCM 10.5.2 with 8831 conference phones.  We have been requested to add a speed dial with a couple of pauses and then a 6 digit code.  This works fine from a 7975 SCCP but not from the 8831 SIP as I believe this is sending ENBLOC VS digit by digit.  IS there a workaround for this with SIP devices?  I tried to disable ENBLOC on the SIP device but did not help.

[Manish Gogna]

Hi Ed,

This is not available on 8831 as of now. Interestingly it works for other 88XX models like 8811, 8841, 8851, 8851NR, and 8861 as per the user guide

http://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cuipph/8811_8841_8851_8861/10_5/english/userguide/P881_BK_C9A41445_00_cisco-ip-phone-8811-8841/advanced_calling_features.html#CUIP_RF_PB885239_00

Not for 8831

http://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cuipph/8831/10_3_1/english/UserGuide/CS38_BK_U841D454_00_userguide-8831/CS38_BK_U841D454_00_userguide-8831_chapter_0101.html

You may check with TAC for any enhancement requests that may be open for the same.

Manish

[mtavarez]

Hi,

I know this is an old thread now, but do you know speed dial with pause is supported on an 8861 connected via Mobile Remote Access?

Thanks

Manny