07-10-2013 01:36 PM - edited 03-16-2019 06:19 PM
Hi,
We are using CUCM 8.6 with MGCP Gateway.
Question:
In SRST mode, if a single gateway has two PRI's. then can we select a specific phone to choose specific PRI's
We have situation, where two departments in the same building using the same gateway. but the PRI billing and number porting is different on two PRI's
1st PRI serves department1 have different DID's and billing
2nd PRI serves department2 have different DID's and billing
Presently department 1 is already on the Gateway and working fine in CUCM as well as SRST mode.
Now New PRI of department 2 is working in CUCM mode and we are about to test the SRST .
In CUCM mode can have more granularity using Route groups and route list. But how to achieve that in SRST mode.
Solved! Go to Solution.
07-10-2013 02:47 PM
You should be able to do this with COR and separate dial-peers per department.
07-10-2013 02:49 PM
+1 COR
This link should give you an overview of how it would be configured
http://www.blindhog.net/maintaining-class-of-restriction-during-srst/
07-10-2013 02:47 PM
You should be able to do this with COR and separate dial-peers per department.
07-10-2013 02:49 PM
+1 COR
This link should give you an overview of how it would be configured
http://www.blindhog.net/maintaining-class-of-restriction-during-srst/
07-16-2013 10:41 AM
It works. Thanks so much guys!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: