cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
339
Views
9
Helpful
3
Replies

SRST basics

omni.moreno
Beginner
Beginner

Hello,

What do I need to check/do to make sure SRST is ready to come up when CUCM or link to it falls down?

Thanks in advance,

1 Accepted Solution

Accepted Solutions

Hi

No. This is the ip address through which the SRST router will communicate with the IP phone in SRST. This will be any ip address on the SRST router which is has interface which will be up like loopback.  Also this is the ip address which you have to give when you configure SRST in Cisco CUCM.

Regards
Ronak Patel

Rate all helpful post by clicking stars below the answer.

Regards Ronak Patel Rate all helpful post by clicking stars below the answer.

View solution in original post

3 Replies 3

ronpatel
Collaborator
Collaborator

HI

You can configure your SRST proerly by using below link

http://www.cisco.com/en/US/docs/voice_ip_comm/cusrst/admin/sccp_sip_srst/configuration/guide/srst_setting_up_using_sccp.html

After configuration you can check the srst configuration validity by doing either following

1) Stop CCM service in CUCM for some time to see if SRST works.

2) Above is not possible in production environment so you can have as ACL configured in branch router which will block all the traffic to CUCM. This will make phone go in SRST mode.

Regards
Ronak Patel

Rate all helpful post by clicking stars below the answer.

Regards Ronak Patel Rate all helpful post by clicking stars below the answer.

Hi Ronak,

By reading the SRST configuration guide I came accross with the following:

Step 2 

ip source-address ip-address [port port]  [any-match | strict-match]

Example:

Router(config-cm-fallback)# ip source-address  10.6.21.4 port 2002 strict-match

Enables the router to receive messages from the Cisco IP phones through  the specified IP addresses and provides for strict IP address  verification. The default port number is 2000.

What does the IP SOURCE-ADDRESS mean? Is it CUCM ip address?

Thx,

Omni

Hi

No. This is the ip address through which the SRST router will communicate with the IP phone in SRST. This will be any ip address on the SRST router which is has interface which will be up like loopback.  Also this is the ip address which you have to give when you configure SRST in Cisco CUCM.

Regards
Ronak Patel

Rate all helpful post by clicking stars below the answer.

Regards Ronak Patel Rate all helpful post by clicking stars below the answer.
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers