cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

AMA-CUCM Troubleshooting: Best Practices for Reading Trace Files

225
Views
0
Helpful
3
Replies
Highlighted
Beginner

SRST configuration Voice gateway Site

Hello everyone,

I'm overwhelmed with the huge amount of information I find when looking for SRST configuration, and Idk at this point what is appropriate in my case

All i want is to register SIP phones when the WAN link is down, and keep the same IP addresses they already have 

All need is the following configuration based on This CiscoPress blog

CUCME-Router(config)# voice register global
CUCME-Router(config-register-global)# mode srst
CUCME-Router(config-register-global)# source-address X.X.X.X port 5060
CUCME-Router(config-register-global)# max-dn 40
CUCME-Router(config-register-global)# max-pool 10
CUCME-Router(config- register-global)# system message SRST Mode

When looking at other articles, I see pools configured under voice register pool with a couple of commands and a lot of other configuration parts : example mentioned in This Article

I need to know if the ciscopress config is enough or should I really add all the commands indicated in the second article

Thank you very much

3 REPLIES 3
Beginner

Re: SRST configuration Voice gateway Site

Hello,

You can define 1 voice register pool configuration block using "id network <address> mask <mask>" for all the phones to register using the phone's same IP address.
You can follow the configurations mentioned in the article.

Hope this helps !
-Rohan
*** Please rate helpful posts ***

Hall of Fame Cisco Employee

Re: SRST configuration Voice gateway Site

The SRST configuration guide on cisco.com has a chapter which is specific for SIP SRST, have you followed that?

HTH

java

if this helps, please rate
Beginner

Re: SRST configuration Voice gateway Site

For now i'm just gathering information, I know that it would be easier if was trying that using real equipement now, but unfortunately I have to do that in a new incoming project, that's why i'm looking for a complete configuration so I can be well prepared
CreatePlease to create content
Content for Community-Ad
August's Community Spotlight Awards