cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
425
Views
0
Helpful
1
Replies
Highlighted
Beginner

SRST Setup

We are looking to setup an SRST router at a branch location.  This location is connected to home office by fiber.  The branch location has a couple of PLARs that need to be available in the event of a network outage or fiber cut.  The PLARs are local to that branch office and connect to the same switch at that branch office.  We have a spare 2801 that can be used.  Any recommended solutions to setup the router for SRST to basically make the 2 PLAR phones active in the event of network outage or fiber cut to home office occurs?

Thanks.

1 REPLY 1
Highlighted
Participant

The 'connection plar' command can provide this on a gateway, with or without SRST. It will depend in the plar entry point, if it's on an fxo local to the branch then no problem, if not then please provide more details and I'll try to help.

Sent from Cisco Technical Support iPhone App

Content for Community-Ad