cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
471
Views
0
Helpful
4
Replies
Highlighted
Beginner

SRST SIP Phone PLAR Configuration

We have a customer that has Cisco 8811 phone and when connected to CUCM, it does a PLAR when going off hook and dials the PLAR extension. Is there a way to configure PLAR for the same 8811 SIP phone when in SRST?

4 REPLIES 4
Highlighted
Rising star

1) You have to use command trunk <PLAR Number> under the e-phone in SRST. So for this configuration to work you have to define the phone with MAC in STST Configuration.

https://networkexpertblog.wordpress.com/2017/10/02/how-to-setup-plar-in-cme/

*** Please rate helpful post; Mark "Accept as a Solution" if applicable

Thanks,
Haris
Highlighted

Haris,

 

That is for the SCCP version of SRST, not for SIP phones operating in SRST mode.

Highlighted

For SIP Phone use the Barge AutoDial Feature

enable
configure terminal
voice register dn dn-tag
number number
intercom [ speed-dial digit-string] [ label label-text]
exit

Refer Below For More details

https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucme/admin/configuration/manual/cmeadm/cmeinter.html#config-inter
https://community.cisco.com/t5/ip-telephony-and-phones/hotline-configuration-with-ip-phone-on-cme/td-p/2591689

*** Please rate helpful post; Mark "Accept as a Solution" if applicable

Thanks,
Haris
Highlighted

Will that work during SRST mode?

Content for Community-Ad