I have CME 12.0 and working fine. From the IP phones we have the FAC codes configured:
fac custom callfwd all *72
fac custom callfwd cancel *73
fac custom park *90
fac custom dnd *78
fac custom redial *69
fac custom voicemail *98
fac custom alias 0 *93 to *903000
fac custom alias 1 *94 to *904000
fac custom trnsfvm *97
fac custom dpark-retrieval *95
How can I get these same codes to work with a POTS analog phone? When I press * and another key, I get a busy signal.
I have tried stcapp but I am getting lost. Here is the phone's current config:
dial-peer voice 302 pots
corlist outgoing Door-National
description Cordless Phone #1
translation-profile outgoing CONVERT_OUTBOUND_CALLER-ID
destination-pattern 102
preference 1
port 0/0/2
