We recently replaced a dead ATA 186 with a 187. Since that time the caller on the analog side is noticing static on their side and the other caller is hearing echo. We have tried changing pairs between the ATA 187 and the analog phone, but the issues will not go away.
Does anyone have any suggestions on how to troubleshoot these issues? I have not tried changing the impednece settings on the ATA 187. Would that make a difference?
There are cases/situations where we have to configure custome CPTONE to resolve FXO disconnect issue. Following are situations which can arise due to FXO disconnect issue:
Phone A calls Phone B, Phone B does not answer. Phone A then goes on-hook but Phon...
Cisco announced major enhancements today to Webex Contact Center. Learn more about the highlights including
better support for the needs of large contact centers worldwide
improvements in the agent and cust...
SymptomsI’m doing a factory reset on the mobile board and it’s giving me the same issues that I wasn’t able to also send over last time. It says that it can’t connect to the server because of a firewall (we don’t have one) and then sometimes it...