cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
754
Views
0
Helpful
6
Replies

Switch configuration to trunk voice and data vlan

ioan_ploscariu
Level 1
Level 1

Hi.

I have 2 switches, 2 vlans/switch, vlan 10 (voice vlan) vlan 20 (data vlan) , 1 MCS with CUCM 7.0.

I want to configure trunking between 2 switches but keep the qos of voice vlan.

This is my interface gigabitethernet 0/1 configuration.

interface gigabitethernet 0/1

switchport mode acces

swtchport acces vlan 20

switchport voice vlan 10

spanning-tree portfast

How i configure gigabitethernet 0/24 to trunk voice and data vlan and keep the qos of voice vlan.

Thanks.

6 Replies 6

Marwan ALshawi
VIP Alumni
VIP Alumni

on the tunk link between the tow switches

int gig0/5

switchport trunk encapsulation dot1q

switchport mode trunk

mls qos trust dscp

this on both side of the switches

also make sure that cos 5 map to dscp 46]by issuing show mls map cos-dscp

this will preserve the qos marking is tat wha you looking for

my question here if you have only tow switches i think qos not an issue unless you have remote sites over a WAN link

anyway good luck

HTH

I have more switches, more locations, but all in a campus switched network.In this moment i don't have voip over WAN link.

commands - show mls map cos-dscp - map cos 5 to dscp 40?it's ok?

thanks.

no it has to to be 46

enter the following command it will fix it to u

mls qos map cos-dscp 0 8 16 24 32 46 48 56

by the way al these config to keep the marking

if you want some sort of prioritization tell me what switches model you are usig and i will try to send you some commands to help in this

good luck

I have catatalyst 2960 and catalyst 3750.

Thank you.

Hi,
I have a link from our Cisco core switch to another Cisco switch, both sides marked with a vlan tag, this works fine. I can ping and connect to my server on this subnet.

The trouble is, the moment I add another link with the same vlan tag (I want to load balance/ have redundancy), the server drops off the face of the earth.

I have tried creating an etherchannel and adding the 2 ports to it, but this doesn't seem to work either.

 

Thanks

On the port connecting to the Cisco IP Phone, try the Cisco macro/command "auto qos voip cisco-phone".

On the 802.1Q trunk use the "auto qos voip trust".

This is usually enough to provide QoS for Cisco IP Phone voice traffic.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: