cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Walkthrough Wednesdays
2522
Views
0
Helpful
2
Replies
Chris Brumley
Beginner

SX20 and Dual Monitor

I'm running ce8.3.0 on an SX20 and it was my understanding that during dual monitor you could display local out to monitor 1 and remote out to monitor 2. I went through the settings but while in conference I am getting the gray screen on monitor 2. Side note: I need to be able to do this without a touch panel, strictly web interface or remote control. Any help would be appreciated.

1 ACCEPTED SOLUTION

Accepted Solutions
Enrico Conedera
Cisco Employee

Hello Chris -

Defaults on the SX20 are far end on screen 1 and local view (if enabled) on screen 2.

In the web interface, set SelfView so that it always appears full screen on output 2.

You can physically reverse the wires so that the screen that you want for remote / far end is the main output #1 on the SX20.

View solution in original post

2 REPLIES 2
Enrico Conedera
Cisco Employee

Hello Chris -

Defaults on the SX20 are far end on screen 1 and local view (if enabled) on screen 2.

In the web interface, set SelfView so that it always appears full screen on output 2.

You can physically reverse the wires so that the screen that you want for remote / far end is the main output #1 on the SX20.

View solution in original post

This seems to resolve the issue until a remote location presents content then the self view reverts back to pip until you maximize it again.

Content for Community-Ad

Spotlight Awards 2021