05-18-2011 05:18 AM - edited 03-16-2019 05:01 AM
Hi All,
We have a requirement to set up a system messge in all our site's IP Phones. As I know, there is a setup for this in CME with the command
'system message' under 'telephony-service' configuration. But is there any possibility that we could setup similar in the CUCM (CallManager) ?
Thanks in advance,
Prathyush Keeriyatt
Solved! Go to Solution.
05-18-2011 07:36 AM
No, that could only be done in CUCM when it was in Windows and you had access to the files where that was stored.
There's no way to do that in any Linux appliance since files are locked down.
HTH
java
If this helps, please rate
www.cisco.com/go/pdihelpdesk
05-18-2011 07:36 AM
No, that could only be done in CUCM when it was in Windows and you had access to the files where that was stored.
There's no way to do that in any Linux appliance since files are locked down.
HTH
java
If this helps, please rate
www.cisco.com/go/pdihelpdesk
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: