cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
1612
Views
15
Helpful
1
Replies

System Message in CUCM

Hi All,

We have a requirement to set up a system messge in all our site's IP Phones. As I know, there is a setup for this in CME with the command

'system message' under 'telephony-service' configuration. But is there any possibility that we could setup similar in the CUCM (CallManager) ?

Thanks in advance,

Prathyush Keeriyatt

1 ACCEPTED SOLUTION

Accepted Solutions
Jaime Valencia
Hall of Fame Cisco Employee

No, that could only be done in CUCM when it was in Windows and you had access to the files where that was stored.

There's no way to do that in any Linux appliance since files are locked down.

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

View solution in original post

1 REPLY 1
Jaime Valencia
Hall of Fame Cisco Employee

No, that could only be done in CUCM when it was in Windows and you had access to the files where that was stored.

There's no way to do that in any Linux appliance since files are locked down.

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate
Create
Recognize Your Peers
Content for Community-Ad