T2 in G703 and IP transmission

[ComstorFR]

Hi

Could Anyone confirm me this this solution ? The goal is to get a connection T2 in G703, making the compression of the 30 channels and transmit the signal into IP.
I plan to put a Cisco2811 router with 4 HWIC and 3PVDM but I need a technical validation.

Thank you for your help

Regards

[paolo bevilacqua]

You probably mean E1 (2 M/bps), not T2.

E1 has 30 channels, T2 has 4 x T1 = 96 channels.

If E1, that is possible. You will need a someone with experience to configure it.

[ComstorFR]

Thank you Paolo

regards

[paolo bevilacqua]

You're welcome, please remember to rate useful posts clicking on the stars below.