cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
556
Views
40
Helpful
15
Replies

Talkaphone not displaying location to 911

jprovine@uic.edu
Beginner
Beginner

I recently configured a talkaphone voip-600 on my Cisco call manager version System version: 11.5.1.14900-11 and everything works but 911 says that there is no information concerning the location of the phone, where does that have to be configured in order to display the address information to 911?

15 Replies 15

TomMar1
Participant
Participant

Either through CER (Cisco Emergency Responder) and/or you would need your service provider to update their PSALI information regarding the DID assigned to the talkaphone.

Okay that's what I thought and when I look in the CER, ERL->conventional ERL and go to the default ERL settings, it appears to have our locations address entered in the street name field, and   it looks like the Talkaphone is using the default.

What is this PSALI ? By provider I assume you mean either our telcom, 911 or both

What you have in CER is not necessarily what the service provider contains in their PSALI DB.

PSALI is a database that your service provider owns and manages in most cases.  That is where location information (street address and more specific location information, building, floor...) is contained and associated to specific DIDs.  When a 911 call goes out via one of those DIDs the PSAP (911) is presented with the specific location information contained in the PSALI database.

In our environment we use 100s of ELINs, each of those has a specific location associated with them in the providers PSALI DB.  When a call goes out to 911 the agreed upon DID is associated with the call, then the PSAP is able to see the specific location information contained within the PSALI DB.