I am using the its-CISCO.126.96.36.199.tcl script to receive a call on a specific dial-peer. When it is hit it is playing the welcome prompt, but if I try to dial any extension no it's not even waiting for the 2nd digit it's saying destination is not reachable even it is unable to transfer the call to the operator. Can anyone please help on this?
My scenario is :
PRI -> MGCP Gateway-1 -> CUCM 8.5 -> SIP TRUNK -> Gateway-1 - > inbound dial-peer -> script plays welcome prompt - X-- nothing after that.. Call get's disconnected.