Earlier in the week, I had recreated time schedules and applied to two new partitions to handle after-hours calls. In those partitions, i created a simple translation pattern to route the call appropriately. It was working, but then yesterday, we cutover a new location to CM and now none of the locations are able to use the routing and calls are failing. If i go through DNA, it shows 'block this call' 'unallocated number'; when i check the order of partitions in the device CSS that's being applied, it skips over the first two, which have the time of day, and goes straight into a 3rd one with a generic pattern to allow intra-office abbreviated dialing...callmanager version is 8.5.1-13900
Hi Yosh--actually, about an hour into it, I had the engineer from our VAR take a look, and apparently, I missed all of Saturday and most of Sunday in the time periods...that's what i get for not having someone take a look when i built it out--hard to recognize flaws in your own code.
After adding those in, though, they're working as intended once again.
Is there a way in UCCE with using an admin script maybe using the email application in Call Studio to send out an email? I know in UCCX you can send out an email if the script were to fail but is there a way to do it in UCCE? Any help would be great!
Fun lab with Packet Tracer and running Cisco CME with 3 ip phones, 3 laptops, 1 switch, and 1 router. Fun lab with repetition. You will be able to test your phones and laptop for connectivity etc. Solution;see attached CME Packet Tracer L...
How to configure IP Address for Cisco Integrated Management Controller CIMC. The Cisco Unified Computing System (UCS) is a data center product composed of computing hardware, virtualization support, switching fabric, and management software.
QuestionHi Team,I just need to confirm if we change NTP servers on UCCX, will it affect the license on UCCX 12.0 ?Do we need to re-host after updating NTP?Already done on CUCM and CUC , and it didn't affect but not sure for CCX. Thank you ...