Hi everyone! I need some advice on the Time-of-Day routing in Call Manager. I already went through most of the posts on Time-of-Day on this forum as well as the CUCM Systems Guide. Based on the suggestions, here is how I am planning to setup on my system:
Old setup of CUCM that uses Partitions such as OnNet, Local, STD, etc (i.e. not scalable PT/CSS)
Shared line needs to go to mobile when no one answers (pretty easy – CFNA)
Same shared line needs to automatically go to an on-call mobile After Hours (Outside of M-F 9-5)
What I have done:
Setup a time schedule for After Hours and assigned it to a “After Hours” partition
Setup a Translation Pattern that lives in the “After Hours” Partition
Shared line lives in the “On Net” partition that everyone’s CSS has access to
Append everyone’s CSS to have the “After Hours” partition sit at the top of the list of Partitions (to make sure the Translation Pattern gets hit before the DN)
With this setup I will need to modify 35x CSS and add my new Partition to the top of each CSS' list of Partitions. Is there a better or easier way to set up my Scenario for automatic Time-of-Day routing (to a mobile after hours)?
Fun lab with Packet Tracer and running Cisco CME with 3 ip phones, 3 laptops, 1 switch, and 1 router. Fun lab with repetition. You will be able to test your phones and laptop for connectivity etc. Solution;see attached CME Packet Tracer L...
How to configure IP Address for Cisco Integrated Management Controller CIMC. The Cisco Unified Computing System (UCS) is a data center product composed of computing hardware, virtualization support, switching fabric, and management software.
QuestionHi Team,I just need to confirm if we change NTP servers on UCCX, will it affect the license on UCCX 12.0 ?Do we need to re-host after updating NTP?Already done on CUCM and CUC , and it didn't affect but not sure for CCX. Thank you ...
Hi I need urgent help on once issue. I need to configure Multicast on my layer 2 and layer 3 switches for Voice Paging server. Singlewire paging server connected with core and end IP phone on layer 2 switches. I need to configure Multicast on layer 2 and ...