08-24-2012 06:58 PM - edited 03-16-2019 12:52 PM
I have a home lab setup with a couple of 7940s, 7960s, 7920s and also one FXS for my house phone with an FXO. I cannot get my IP Phone to transfer calls to my house FXS. I can transfer calls from my analog phone to IP phones though. Thanks in advance for the help. Attached is my full current config.
Solved! Go to Solution.
08-24-2012 07:44 PM
You don't have any transfer-patterns defined under telephony-service, try adding one matching your internal DN range.
HTH,
Chris
08-24-2012 07:44 PM
You don't have any transfer-patterns defined under telephony-service, try adding one matching your internal DN range.
HTH,
Chris
08-25-2012 11:51 AM
OK, I added transfer-pattern 1... and it lets me dial 1100 which is my analog phone, but I get Busy in my display and hear the busy tone. What is going on now????? thanks
08-25-2012 06:40 PM
Thanks for getting me correct answer, I have finally figured it out. The ephone buttons I had were wrong and under CLI sh stcapp dev summ was showing my FXS registered as my home phone number and not there DN number. Thanks
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: