cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
801
Views
0
Helpful
20
Replies
Beginner

Hi,that's right - calling and

Hi,

that's right - calling and called parties are both registered to same cucm cluster. Thanks for tip with OnNet and OffNet. I'll look at this in detail.

Best regards

Frank

Beginner

Does route pattern has any

Does route pattern has any effect in this case? Call is from one extension to another extension.

Highlighted
Enthusiast

Hello everyone!I think, Route

Hello everyone!

I think, Route Pattern '8000' can be created and put in Partition_1, that listed 1st in existing CSS, but then it should go to any gateway and return back to CUCM. 

On Gateway config page u wil need to configure CSS for inbound calls without Partition_1, so call will go to CC.

So it will be difficult Dial Plan.

Why don't you want tot try change Calling Party Number Type from Cisco CallManager to any other in Translation Pattern?

Mat be it will be treated as offnet call?

 

we are facing a similar issue

we are facing a similar issue . All internal calls are routing via E1 PRI hence we are being charged by service provider for IP phone IP phone calls .both calling and called parties are registered in the same CUCM .E1 PRI is terminated to an H.323 Gateway .what need to be done for this ??
 

Rising star

The issue which you are

The issue which you are facing is completely different.

Suresh

Beginner

When agent one calls service

.

CreatePlease to create content
Content for Community-Ad
August's Community Spotlight Awards