Two IP Address management on VG Router

[aelankoud]

Hi everyone,

I installed CUCM 11.5, and CUCME v7 on same LAN, I have 14 VG Router for Fax configured on CME, Now I want to configure VG Router in CUCM, is it possible to define two management IP addresses in the VG Router, the first of CME and the second of CUCM, in this case if the CME fall off, it will retrieve the configuration of CUCM after restarting.

thank in advance for your help.

[Jaime Valencia]

What protocol are you going to use here??

If it's MGCP, then that's only applicable to CUCM, CME does not handle MGCP GWs