cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Walkthrough Wednesdays
181
Views
0
Helpful
1
Replies
Brendon Bell
Beginner

UC520 - Port config

I would like to hang a HP wireless access point off port fa0/1/8 and deliver PoE to it.

The A/P is to be assigned 192.168.100.252.

Currently fa0/0 has the ip address 192.168.100.251/24.

Ports fa0/1/0 to fa0/1/7 are in voice vlan 100.

Appropriate section of the config below:

interface Loopback0

description $FW_INSIDE$

ip address 10.1.10.2 255.255.255.252

ip virtual-reassembly

!

interface FastEthernet0/0

description $FW_OUTSIDE$

ip address 192.168.100.251 255.255.255.0

ip nat outside

ip virtual-reassembly

duplex auto

speed auto

crypto map IPSEC-TRAFFIC

!

interface Integrated-Service-Engine0/0

ip unnumbered Loopback0

ip nat inside

ip virtual-reassembly

service-module ip address 10.1.10.1 255.255.255.252

service-module ip default-gateway 10.1.10.2

!

interface FastEthernet0/1/0

switchport voice vlan 100

macro description cisco-phone

!

interface FastEthernet0/1/1

switchport voice vlan 100

macro description cisco-phone

!

interface FastEthernet0/1/2

switchport voice vlan 100

macro description cisco-phone

!

interface FastEthernet0/1/3

switchport voice vlan 100

macro description cisco-phone

!

interface FastEthernet0/1/4

switchport voice vlan 100

macro description cisco-phone

!

interface FastEthernet0/1/5

switchport voice vlan 100

macro description cisco-phone

!

interface FastEthernet0/1/6

switchport voice vlan 100

macro description cisco-phone

!

interface FastEthernet0/1/7

switchport voice vlan 100

macro description cisco-phone

!

interface FastEthernet0/1/8

switchport mode trunk

macro description HP-access-point

!

interface Vlan1

description $FW_INSIDE$

ip address 192.168.10.1 255.255.255.0

ip nat inside

ip virtual-reassembly

!

interface Vlan100

description $FW_INSIDE$

ip address 10.1.1.1 255.255.255.0

ip nat inside

ip virtual-reassembly

!

Thanks,

Brendon.

1 REPLY 1
brmeade
Enthusiast

What exactly do you need help with?  Is it not working just set up as a trunk?  You will probably get better input over at the LAN Switching section.

Content for Community-Ad

Spotlight Awards 2021