I have set up fax to email on my UC560, though recently switched vendors for our telephony service. I thought it was going to be a straigh pri-pri switch, but it was not. I'm being asked to set my system to receive at 9600bps. Is there a way to do that in the UC500 series?
I had previously set up my uc560 to do fax to email, sample config here with one of the did dial peers:
!
fax receive called-subscriber $d$
fax interface-type fax-mail
mta send server 10.1.10.1 port 25
mta send with-subject both
mta send mail-from hostname 10.1.10.2
mta send mail-from username $s$
mta receive aliases 10.1.10.2
mta receive maximum-recipients 7
!
application
service cca_fax_detection flash:/applications/faxmail/app_fax_detect.2.1.2.2.tcl
param fax-dtmf 2
param mode listen-first
param voice-dtmf 1
param prompt flash:/applications/faxmail/en_listen_first.au
!
service cca_offramp flash:/applications/faxmail/app_faxmail_offramp.2.0.1.1.tcl
!
service cca_onramp flash:/applications/faxmail/app_faxmail_onramp.2.0.1.3.tcl
!
!
!
dial-peer voice 3016 pots
description 5017_T37
translation-profile incoming 5017_T37_Called_21
service cca_onramp
incoming called-number 5017
direct-inward-dial
port 0/3/0:23
!
!
voice translation-profile 5017_T37_Called_21
translate called 21
!
!
voice translation-rule 21
rule 1 /5017/ /208/
!
.png "Hall of Fame"){kind=icon}