cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
220
Views
0
Helpful
2
Replies
Beginner

UC560 with FXS ports that gets useless after some time of use

Hi everyone,

I've an UC560 with 4 FXS ports built-in.

In 2 of the 4 ports of the UC, I've configured 2 stcapp phones.

After some time of use, these 2 ports became unavailable, so I've to make the command "shut" and "no shut" to return to life these 2 ports. They remain working during some amount of time and became unavailable again, and the solution is the same, "shut" "no shut".

Anyone have experienced this?

Here's the configuration of the ports:

voice-port 0/0/2

compand-type a-law

cptone PT

timeouts interdigit 20

timeouts ringing infinity

station-id number 341

caller-id enable

!

voice-port 0/0/3

compand-type a-law

cptone PT

timeouts interdigit 20

timeouts ringing infinity

station-id number 350

caller-id enable

dial-peer voice 3 pots

corlist incoming internacional

service stcapp

clid network-number 341

port 0/0/2

!

dial-peer voice 4 pots

corlist incoming interna

service stcapp

clid network-number 350

port 0/0/3

ephone-dn  41  dual-line

number 341

corlist incoming internacional

!

!

ephone-dn  50  dual-line

number 350

corlist incoming interna

Best Regards,

LuisM

2 REPLIES 2
Beginner

UC560 with FXS ports that gets useless after some time of use

Hi,

You can try to configure the following command on the FXS voice-ports and see.

voice-port 2/0

timeouts power-denial 2500

http://www.cisco.com/en/US/docs/ios/voice/fxs/configuration/guide/fxsbasic.html

Regards,

Gnaneswaran.

Beginner

UC560 with FXS ports that gets useless after some time of use

Hi,

Thanks for the tip, I'll try it.

Best Regards,

LuisM.

CreatePlease to create content
Content for Community-Ad
August's Community Spotlight Awards