cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
615
Views
0
Helpful
3
Replies

UCCX PORTS AND ROUTE POINT

ansarjavaid54
Level 1
Level 1

Hello guys.

Today i installed UCCX with demo license. Am stuck in route point and cti ports registration process. They are in created in cucm but whith status of none normally they are registered with call manager...

Immediate response will be highly appropriated.

3 Replies 3

Jitender Bhandari
Cisco Employee
Cisco Employee

Hi 

Did you perform all the required steps as stated in below link

http://ciscoshizzle.blogspot.in/2013/04/uccx-configuration-basic-set-up-and.html

https://ccieroot.com/2015/07/29/uccx-integration-with-cucm/

(Rate if it helps)

JB

is there a way here to send you a private message Jitender Bhandari

Adding on to the below links shared by JB, if the integration is as per the links you can try below procedure as well

Reset the username and password for Jtapi user on CCX under Telephony Subsystem.Restart the CTI manager on all CUCM servers. Restart CCX engine. 

You can also do the Data Resync.

HTH

Regards

Abhay

Kindly rate all helpful posts !!! 

Regards
Abhay Singh Reyal
The Only Way To Do Great Work Is To Love What You Do. If You Haven’t Found It Yet, Keep Looking. Don’t Settle
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: