cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Webcast -VXLAN BGP EVPNt
115
Views
0
Helpful
4
Replies
Beginner

UCM GUI is sluggish after upgrade to 10.5(2)SU2a (10.5.2.12901-1)

I recently upgraded from a 10.5.2 release to 10.5(2)SU2a, and it all works fine. But the GUI is sluggish compared to earlier versions. Adding and updating phones takes perhaps twice as long to add or save. If an add or change took 2-3 seconds I'm going to say it now takes 5-7. Very noticably slower. Has anyone else seen this behavior?

4 REPLIES 4
Cisco Employee

can you please status of

can you please status of "Show status command from CLI and also did you tried to restart CM and see any change ?

Regards

Nadeem Ahmed

PS: Please rate all useful post

Br, Nadeem Please rate all useful post.
Highlighted
Beginner

Oops. I was going to restart

Oops. I was going to restart Tomcat on the pub and see if it helped. That did it. Weird, I've never had it run slow like that. Must not have started right after the upgrade. Thanks for the response.

Beginner

Hope that you do not have Vm

Hope that you do not have Vm snapshots on Esxi, because that cause also cause issues when it comes to these issues.

Regards,

Ronak Agarwal

Beginner

No we're not using that.

No we're not using that. Thanks

CreatePlease to create content

Ask the Expert French- routing protocols