If I remember correctly - we set up a few of these a year or two back...you have to plug in a plain regular phone into the analog port and listen for commands to set it up - they are actual voice menus you hear.
You then use Voice Menu Codes to get the device programmed. See page 133 of the "Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide (SCCP)".
You can then program its info to get it on your network. And then you have to add to Call Manager as well, but it is tricky as you have to "adjust" the MAC address to access the second port.
For example, the primary port is accessed like any other phone - use the MAC...we have one "ATA0019E8512902". But to get the second port working, you add another device and slide the MAC address 2 places to the left, drop the leadning zeros, and add an "01" to the end. So the second port of the deivce is "ATA19E851290201"
Hope this helps. Who would think to use an analog to IP conversion box, you would need to plug in an analog phone and listen to a voice menu to program it.
Have fun..neat devices. The Admin guide tells all. Good luck!
I have some good news for you as I have had this exact problem!
Assuming that you have already enabled web access on the device you need to also enable the “web access” parameters on CUCM at the below levels, it will be disabled by default. I enabled them in both of these locations and Bam! Web access.
Enterprise Phone Configuration window
System > Enterprise Phone Configuration
Common Phone Profile window
Device > Device Settings > Common Phone Profile
As a side note, now that I do have web access, I reverted both settings back to standard and I still have access. Go figure... not like Cisco to have a gremlin in their system...
Assuming now that webaccess is "granted" the device setting is now in effect.
Edit: Also on the device profile, if you enable ssh you can ssh to the device (9600/8/1) default username and password is ciscossh.
You want in some scenarios different URIs or call-IDs and different access code are used by guest and host participants to join a meeting, and different rights or privileges, for example add or remove participants, mute audio or video, or when there...
Opus is an adaptive codec that provides better audio call quality than G.711/G.729 voice codecs and in a low bandwidth environment. The codec has a very low algorithm delay and is it is highly scalable in terms of audio bandwidth, bitrate, and comple...
Background:When deploying a multisite with centralized call processing across multiple countries, the digit manipulation can be complex, in this scenario US Site as HQ, GE Site in Germany and AU Site in Australia use different dial plan.We need to unified...
Version 3.3 introduces the ability to schedule meetings and see upcoming meetings in web app. Web app users can schedule meetings, modify the scheduled meetings, and notify participants via email. Scheduler is a new component that enables scheduling meeti...
Translation Profile is used on Voice Gateway to perform Digit Manipulation on the Calling and Called Parties. The Translation Pattern is doing the same digit manipulation. The translation profile can be applied BEFORE the incoming dial peer is matched (if...