I am having difficulty blocking internal Directory Numbers from a particular set of phones.
What I am trying to achieve is as follows:
- I have a set of phones with DNs 5301 - 5310
- I want to allow them to call each other, but I don't want them to receive any incoming calls, except from 5301-5310
- Outside of their group, I only want to allow them to call a specific number 7016
- I would still like Call Pickup to Work
I tried to do the above by placing the above DNs in their own partition and this takes care of the incoming side of things. I then created a dedicated CSS that only contained the partition with the above DNs.
However it would seem that I also need a Block Pattern for everything outside of 5301-5310 & 7016
Do I need to do this by creating multiple block patterns and assigning those to the Partition I created, I'm hoping there is some clever wildcard or ^ I can use.
NIM-PVDM is the Next-generation digital signal processor (DSP) module with an onboard DSP daughter card which eliminates the need to procure an additional T1/E1 NIM card in order to utilize a PVDM4 chip for IP media services. This module enables the new C...
QuestionGood morning. I am looking for the equivalent of the System Manager Guide Supplement for the SS7INNIC as found on the UCCE CallRouter. Specifically, There should be a table for the EMSUserData Mapping so I can drill down on specific informati...
Hello guys,As I have read the Facebook messenger could integrate with UCCX to handle chat as webchat support,. there is a webhook on Facebook that instructed us to write the CCP URL with HTTPS as a Callback URL after writing the tokens from UCCX to FB and...