I was trying to configure Cisco 8821 phone to connect to CUCM 10.5.2 via Maraki APs.
I do not get the option on the phone to configure WPA/WPA2.
I have the latest phone loads.
WLAN driver id
WLAN firmware ID
I have configured everything following Cisco recommendation. Any suggestions about any settings that I could have missed. I have been following this guide...
Cisco Wireless IP Phone 8821 and 8821-EXWireless LAN Deployment Guide
I have this problem too.
Seems if you use PSK on the 8821, it only supports WPA2. I hope this is a firmware bug...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: