cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1361
Views
0
Helpful
6
Replies

Unity 8.5.1 Replication error

kalbasha0
Level 1
Level 1

I'm getting replication status error message # 3 between our Unity pub and Sub servers

I have run the following form the pub

Utils dbreplication status

Copy current replication file and receive the error

Pub status is 2 active local

Sub status is 3 active connected

I need assistance to resolve the replication issue

Current environment

Unity 8.5.1.10000-206

Thx

6 Replies 6

David Hailey
VIP Alumni
VIP Alumni

A database status of 3 translates to the following state:

3 (Broken) — Replication failed during setup and is not working

For this state, the first thing to do is to reboot the Subscriber server and see if the replication issue is resolved.  Have you done this yet?

Hailey

Please rate helpful posts!

Yes i did , however no luck

Check out the following guide...it refers to CUCM but the procedures for troubleshooting the DB are the same:

https://supportforums.cisco.com/docs/DOC-8194

I tried everything with no luck . Still the same error message 3

If you have performed a repair as well as a reset and verified host name and other settings as per the document and replication is still broken, then it would be in your best interest to open a TAC case so that you can receive some hands-on assistance in troubleshooting and resolving the issue.

Hailey

I'm guessing when you say you tried everything, you have already verified DNS? [if your installation is using DNS.]

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: