I'm wondering if anybody has come across this before and can give me some advice.....
I've installed Unity connection 7.1.3 onto a Hp mirco server - the install went fine with no errors. the system boots and everything looks good and intergration between unity cnx & cucm 8.5 went fine.
However the problem starts when you press the messages button on the phone - first you get the message "please enter your pin number and press #" but as soon as you enter in any digit the system stops & the line goes dead. if you try and call voicemail back you get a fast busy tone.
Looking at the system the ports unregister with cucm for a couple of minuites andn them come back, looking on the unity serviceability page i can see that the Conversation mixer service restarts.
I'm making a assumption that this could have something to do with the fact that the HP microsever is using an athlon processor as I had to do a bit of a fix for the IP streaming media service in CUCM ( copying and renaming .i686 folders to .athlon)
I've tried this on unty connection and it makes no difference - I still get the same problem.
I'm assuming this a hardware problem / mismatch as this version of unity connection installs fine on another esxi server of a different brand but runs really slow hence the upgrade to a new server.
Configuring Cloud Connected PSTN (CCP) – Easy as 1-2-3!
STEP 1: PREPARE
Before you can configure your CCP in Control Hub, you must procure PSTN services from an authorized Webex Calling CCP Partn...
To participate in this event, please use the button to ask your questions
This topic is a chance to discuss more about how to read Cisco Unified Communications trace files. In this session, Cisco D...