Hi people.
I have some issues when integration UC-CME via SCCP. Every thing works just fine except MWI lights do not work on SIP phones.
Here is the config from CME router:
voice service voip
allow-connections sip to sip
no supplementary-service sip moved-temporarily
sip
bind control source-interface FastEthernet0/0.200
bind media source-interface FastEthernet0/0.200
registrar server expires max 600 min 60
!
!
voice register global
mode cme
source-address x.x.x.x( FastEthernet0/0.200) port 5060
max-dn 20
authenticate register
voicemail 4001
tftp-path flash:
!
voice register dn 1
number 3002
call-forward b2bua busy 4001
call-forward b2bua noan 4001 timeout 7
allow watch
name BR2 Phone 2
mwi
!
voice register pool 1
id mac XXXX.XXXX.XXXX
type 7970
number 1 dn 1
presence call-list
dtmf-relay sip-notify
username farmer password cisco
codec g711ulaw
!
!
sip-ua
mwi-server ipv4:y.y.y.y expires 3600 port 5060 transport tcp unsolicited
!
!
telephony-service
max-ephones 20
max-dn 20 no-reg
ip source-address x.x.x.x port 2000
voicemail 4001
max-conferences 8 gain -6
call-forward pattern .T
mwi relay
!
!
ephone-dn 1 octo-line
number 3001 no-reg primary
name BR2 phone 1
allow watch
call-forward busy 4001
call-forward noan 4001 timeout 9
!
ephone-dn 10 dual-line
number 4001
preference 1
huntstop channel
no huntstop
!
ephone-dn 11 dual-line
number 4001
preference 2
huntstop channel
!
ephone-dn 20 dual-line
number 8000 secondary 8001
mwi on-off
!
ephone 1
device-security-mode none
mac-address XXXX.XXXX.XXXX
max-calls-per-button 5
busy-trigger-per-button 3
username frank password 12345
presence call-list
type 7965
button 1:1
!
ephone 10
device-security-mode none
vm-device-id CUC-VI1
button 1:10
!
ephone 11
device-security-mode none
vm-device-id CUC-VI2
button 1:11
