Hi there,
voicemail conversation caller recording-prompt
To enable playing a prompt to a caller to record a message, use the voicemail conversation caller recording-prompt command in Cisco Unity Express configuration mode. To disable the prompt, use the no form of this command.
voicemail conversation caller recording-prompt
no voicemail conversation caller recording-prompt
Syntax Description
This command has no arguments or keywords.
Defaults
The default is enabled (the system plays the prompt).
Usage Guidelines
The caller hears the following message after the recipient's greeting plays: "Record your message after the tone. When you are finished, hang up or press # for more options." Use this command to enable or disable the playing of this prompt.
To display the status of the caller recording-prompt, use the show running-config command. If the prompt has been disabled, the following line appears in the output:
no voicemail conversation caller recording-prompt
The show running-config output will not display any status of the prompt if the prompt is enabled.
Examples
The following example disables playing the caller record-prompt:
se-10-0-0-0# config t
se-10-0-0-0(config)# no voicemail conversation caller recording-prompt
se-10-0-0-0(config)# end
se-10-0-0-0#
https://www.cisco.com/en/US/docs/voice_ip_comm/unity_exp/rel3_2/Command/v_cmds.html#wp1016219
Cheers!
Rob
Please support CSC Helps Haiti
https://supportforums.cisco.com/docs/DOC-8895
https://supportforums.cisco.com/docs/DOC-8727
