cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
761
Views
0
Helpful
3
Replies

Upgrade or new installation, Callmanager 7.0.2.20000-5 to 8.6?

alig.norbert
Enthusiast
Enthusiast

Hi all,

I have a CCM 7.0.2.20000-5 that should be upgraded to 8.6.

As mentioned in http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/compat/ccmcompmatr1.pdf , a direct upgrade is not possible.

I suppose an upgrade to 7.1x and then to 8.6 is not possible either, because 7.1x is EoS.

How can this be done? A new installation from 8.6 and a restore from 7.0.2?

Thanks for a hint.

Greets,

Norbert

1 Accepted Solution

Accepted Solutions

paolo bevilacqua
Hall of Fame Master Hall of Fame Master
Hall of Fame Master

If remember correctly, CUCM doesn't supports cross-release restore (wow).

If so, your only choice is either somehow obtain 7.1 media , or BAT export, and re-import.

View solution in original post

3 Replies 3

paolo bevilacqua
Hall of Fame Master Hall of Fame Master
Hall of Fame Master

If remember correctly, CUCM doesn't supports cross-release restore (wow).

If so, your only choice is either somehow obtain 7.1 media , or BAT export, and re-import.

If I can get a 7.1 media, the licenses from the installed 7.0.2 should still be active on the 7.1, right?

Well, let's asking our cisco sales ;-)

Thanks,

Norbert

Jaime Valencia
Hall of Fame Cisco Employee Hall of Fame Cisco Employee
Hall of Fame Cisco Employee

Paolo is correct, CUCM restores have always been on the EXACT (all the way to ES, SRs, etc) same version from which the backup was taken.

If you're going to do this all in one step you do not need any 7.1 licenses, once you upgrade to 7.1 you can immediately upgrade to 8.6 and then install the new licenses.

HTH

java

if this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: