Using 8841 K9 phone on an Asterisk server

[gary.hicks]

I am testing the ease of moving our 8841 phones over to an Asterisk server (FreePBX and Xorcom are the test platforms).  I have pulled the phone cnf file from CUCM and modified the server information to be the Xorcom server and I have set alternate TFTP address on the phone to point to the Xorcom server.

At this time all I am getting is the registering message on the phone.

The following is the cnf file.  Does anyone have suggestions on what I need to modify to get this to work?

[HARIS_HUSSAIN]

Refer Below links

https://community.spiceworks.com/topic/1335724-cp-8851-on-asterisk
https://www.voip-info.org/asterisk-phone-cisco-79xx/

*** Please rate helpful post; Mark "Accept as a Solution" if applicable

Thanks,
Haris

[Leo Laohoo]

A known working SEPmacaddress.xml.cnf can be found HERE.

[gary.hicks]

Thank you for the quick response.  I will try this today.

[gary.hicks]

I updated the configuration file. At first, I looked on the phone and saw the status message that it could not find a .sgn file so I changed the name of the config to include that.  I am still only seeing "Phone is registering"

Attached is the current configuration file, the phone status messages, and the phone network settings.

the Xorcom Asterisk server IP address is 10.12.50.41