Using both switch ports on a Cisco 8851 and/or 8861 phone for redundancy

[gcopeland]

Can an 8851 or 8861 phone be connected to two switches (PVST running on switches) to supply redundancy to the end-point device.  Using CUCM 11.5.  No Computer connectivity needed.

See Attached Diagram

[Jaime Valencia]

No, there's no way to do that. You can only have one cable from the switch to the phone. The internal switch is not meant to do any of that.

[Leo Laohoo]

To add to Jaimie's response, the phone has two ports.  One of them is PoE.  So how is the 2nd one be "redundancy" if one is NOT PoE?