03-04-2017 08:20 AM - edited 03-17-2019 09:42 AM
We are running CUCM 11.0 and trying to get a vg224 to register to it. Here is the config:
sccp local FastEthernet0/0
sccp ccm cucm-sub2.staff.fusd.local id 1
sccp ccm cucm-pub1.staff.fusd.local id 2
sccp ccm 10.213.160.2 id 3
!
ccm-manager config server cucm-sub3 cucm-pub1
ccm-manager config
ccm-manager sccp local FastEthernet0/0
ccm-manager sccp
!
sccp ccm group 1
bind interface fa0/0
ass ccm 1 priority 1
ass ccm 2 priority 2
ass ccm 3 priority 3
switchback method graceful
!
!
voice service voip
stcapp
The vg224 keeps on registering to the local gateway - 10.223.160.2 and not to the subscriber. Any thoughts here?
03-04-2017 08:27 AM
Hi,
I would want to test the DNS first and see if there is any issues with resolving the URL / Hostnames to IP Addresses for the CCM Servers.
If that checks out fine, then the MAC Address for the VG on the CCM.
HTH
Plz rate all helpful posts.
03-04-2017 09:39 AM
The DNS appears to be fine and changed the config:
from:
sccp local FastEthernet0/0
sccp ccm cucm-sub2.staff.fusd.local id 1
sccp ccm cucm-pub1.staff.fusd.local id 2
sccp ccm 10.213.160.2 id 3
to:
!
sccp local FastEthernet0/0
sccp ccm 10.213.160.2 identifier 4
sccp ccm 10.223.250.12 identifier 2
sccp ccm 10.223.250.14 identifier 1
sccp
!
The MAC address appears to be fine:
vg224-servicecenter-m-6#sh int fa0/0
FastEthernet0/0 is up, line protocol is up
Hardware is Gt96k FE, address is 001f.9e58.bfd4 (bia 001f.9e58.bfd4)
Internet address is 10.213.160.9/24
Mac Address (Last 10 Characters) - 1F9E58BFD4
Any other thoughts here?
03-04-2017 10:23 AM
Make sure the Device pool assigned to the devices in CUCM uses CUCM group that matches the CUCM servers listed in your configuration.
Also, I don't see "sccp" in your config, please enter "no sccp", followed by "sccp".
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide