Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
1085
Views
0
Helpful
1
Replies

VG224 SCCP using Loopback

shane.orr
Level 4
Level 4

‎08-09-2010 05:40 PM - edited ‎03-16-2019 12:09 AM

I know there are a few old posts regarding this subject but wanted to get some newer input and just need a little clarification.  I was wanting to configure my VG224 with redundant paths to the network so utilizing a loopback address for binding voip traffic to.  I was also wanting to utilize SCCP for SRST and other advantages stated elsewhere.  However, the SCCP configuration in CUCM needs a MAC Address and the Loopback obviously does not have one so what are my options these days?

I know with MGCP I could bind it to the loopback and the protocol is hostname based anyway so MAC address does not factor there.

Any ideas?

Shane

Labels:
0 Helpful
1 Reply 1

paolo bevilacqua
Hall of Fame
Hall of Fame

‎08-09-2010 06:00 PM

You can use a loopback address to reach VG224 (probably not necessary, better would be a BVI comprising the two LANs), and that will not affect the SCCP MAC addresses. These are indipendent things.

0 Helpful
Customers Also Viewed These Support Documents