cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
5619
Views
0
Helpful
11
Replies

VG320 Configuration for CUCM

dlcharville
Enthusiast
Enthusiast

Sure hope I'm missing something but can someone tell me where or how to configure a VG320 (IOS 15.4(3)M1) for SCCP to CUCM 10.5?  None of the voice-port commands are present.  I have the VG320 configured in CUCM as SCCP with last 10 of MAC.  I also have the SCCP commands configured on the VG320.

This is the first VG320 I have configured.  I have configured a few VG350's with no issue.

Thanks,
Dan

1 Accepted Solution

Accepted Solutions

To close the thread, VG320 ships with one PVDM3-128. In this case we confirmed the PVDM3 was missing hence no voice-port configuration could be done.

View solution in original post

11 Replies 11

Which voice port configuration are you referring to. You don't need to apply any configuration at the port level for sccp to work.. sample configuration is shown below 

stcapp ccm-group 1

stcapp
sccp local FastEthernet0/0

sccp ccm 10.4.131.200 identifier 7815

sccp ccm 10.4.138.77 identifier 7825

sccp

!

sccp ccm group 1

 associate ccm 7815 priority 1

 associate ccm 7825 priority 2

!

!

dial-peer voice 500 pots

 service stcapp

 port 2/0

!

dial-peer voice 501 pots

 service stcapp

 por