Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
356
Views
0
Helpful
2
Replies

VIC2-2BRI-NT/TE will support DSUs - U Interface Features

Naveen Subramaniam
Level 5
Level 5

‎08-09-2016 11:00 PM - edited ‎03-17-2019 07:47 AM

Hello All,

Could you please any one advise, VIC2-2BRI-NT/TE will have capability to support DSUs (mean U interface Features) ?

mean  1-Port HWIC-1B-U is designed to support  U interface with single pair wire (RJ-48C connector) , but same line can be used to connect with VIC2-2BRI-NT/TE  cards? 

Thanks in advance!!

best regards,

Naveen

1 person had this problem
Labels:
0 Helpful
2 Replies 2

Mohammed Khan
Cisco Employee
Cisco Employee

‎08-10-2016 02:55 AM

Hi Naveen,

To configure the VIC2-2BRI-NT/TE as an N/T device (U interface) use below command
"isdn layer1-emulate network"

Regards,

MK

0 Helpful

Naveen Subramaniam
Level 5
Level 5
In response to Mohammed Khan

‎08-10-2016 03:00 AM

Hi Mohammed,

Thanks a lot your advise & support.

The cabling is only one pair, could you please advise i need to use VIC2-2BRI-NT/TE - RJ 48 pin 4 & 5. k.

best regards,

Naveen

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents