VIC2-4FXS/DID in 3845 setup Guide

[Shahab Salour]

I am setting up a vic2-4FXO/DID in a 3845 router as a personnal experiance as below.

IOS is c3845-adventerprisek9-mz.151-4.M3

voice-port 0/1/0
signal loop-start
cptone us
ring frequency 25

no shutdown

voice-port 0/1/1
signal loop-start
cptone us
ring frequency 25

no shutdown

dial-peer voice 401 pots
desttination-pattern +14085553737
port 0/1/0

dial-peer voice 402 pots
desttination-pattern +14085554141
port 0/1/1

num-exp 3737 +1408555373
num-exp 4141 +14085554141

Scenario consists of 2 handsets which have to call each other by 3737 or 4141

everything seems to be fine.

except, when I dial the other number, i get a busy tone & 2ndd handset doesn't ring.

[Aditya Gupta]

Why do you want to plug handset(analog phones) in FXO ports ?

[Shahab Salour]

I am using FXS module.

[Roger Kallberg]

One of your num-exp seams to be wrong, num-exp 3737 +1408555373

Change this to num-exp 3737 +14085553737

Please rate all useful posts.

Sent from Cisco Technical Support iPhone App

[Shahab Salour]

Thank you Roger.

It was a mistyping. The router configuration is correct.

[paolo bevilacqua]

I see that a correct answer by Roger, made with the will to help, has been low-rated. That should never happen!

I've rated it again to partially compensate.

[Roger Kallberg]

Thank you Paolo for the appreciation.

Sent from Cisco Technical Support iPhone App

[Shahab Salour]

Dear Paolo,

Thanks to your special attention to the subject.

As I mentioned in my reply to Roger, I mistyped it in discussion, while it is correct in router configuration file.

Meanwhile, please help to solve the problem.