cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
254
Views
1
Helpful
1
Replies

video gets stuck when call is made between Cisco IP Phone and Huawei

malik401
Beginner
Beginner

Dear Members,

 

I am facing a problem when video call is made between Cisco IP Phone (8865 registered on call manager version 12.5.1) and Huawei IP Phone (which is registered on Huawei IMS). The video gets stuck on the screen of the Cisco IP Phone after every 15 minutes.

Call flow is below:

Site A------------>          Site A-------------->     Site B-------------------------------->     Site B            

IP Phone                       Cisco Call Manager         SIP Trunk b/t SBC & Call Manager                Huawei IP Phone

Registered on CUCM                                                                                                             Registered on IMS

(SIP)                                                                                                                                          (SIP)

 

what troubleshooting steps are required to fix such kind of issues. does anyone faced similar issue. your support in this regard will highly be appreciated 

1 Accepted Solution

Accepted Solutions

Hi,

What codecs are used? Try to change the codecs and see if it works. I have
seen similar bug with video when audio codec was iLBC 24.

Also, is it exact 15 mins? Enable debug ccsip message and see what happens
at that moment. You might be having an interopert issue where one party
sending a message that is not acceptable by the other one and causing this
freeze.

Is there any xcoding to DSP resources involved in the video calling.? That
can be another issue.

***** please remember to rate useful posts

View solution in original post

1 Reply 1

Hi,

What codecs are used? Try to change the codecs and see if it works. I have
seen similar bug with video when audio codec was iLBC 24.

Also, is it exact 15 mins? Enable debug ccsip message and see what happens
at that moment. You might be having an interopert issue where one party
sending a message that is not acceptable by the other one and causing this
freeze.

Is there any xcoding to DSP resources involved in the video calling.? That
can be another issue.

***** please remember to rate useful posts
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: