OK i just wanted to make sure i was following the correct config. I thought if there is a better way to do this then i am open to that.
Thanks for the reply.
Is the "AA" a service you have running in CME (i.e. BACD) or is it the attendant application running in CUE? Or something else altogether. Islam is hunting the the BACD angle here. Your original dial-p suggested you may have AA enabled in CUE (or similar).
To dig deeper, we'll need output from:
show run | s application
show run | s ephone-dn
sh run | s telephony-s
sh run | s dial-peer
If you are trying to use CUE for the AA then we'll need you to session into CUE and provide the output of "show run"
Please remember to rate helpful responses and identify
Thanks for all who replied. This problem has been fixed.
I was using a hunt-group of 100.
voice hunt-group 100 parallel
Thanks Keith for updating us. That really was a nasty one..I looked online to see what the issue could be but didnt find anything..Nice work..(+5)
Please rate all useful posts
"opportunity is a haughty goddess who waste no time with those who are unprepared"