cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
263
Views
10
Helpful
7
Replies

Voice module for Cisco 2911 router

Clay Plaga
Participant
Participant

I have an SM-SRE-700 voice module. Can I install this module in a Cisco 2911 router? The SM-SRE-700 voice module was pulled from a Cisco 2911 at my job that was not being used. I have a test network with working Cisco phones running on the 2911. I want to try to configure voice mail on my test network .

Thank you.

3 Accepted Solutions

Accepted Solutions

Maren Mahoney
VIP Advocate VIP Advocate
VIP Advocate

Yes, that module will go into a Cisco 2911 router. (If it came out of one, it stands to reason it would go into another.)

Are you hoping to install Unity Connection on it? I know you can install Unity Connection in SRSV mode on that module. It also supports Cisco Unity Express. I don't know if you can install full Unity Connection, though.

Maren

View solution in original post

Nithin Eluvathingal
VIP Mentor VIP Mentor
VIP Mentor

I have one 2911 with SM-SRE-700 in my lab.. You can use SM-SRE-700 on 2911 and configure unity express up to 8.6. Unity express 9 and 10 are virtual and not supported on SM-SRE-700.

For unity express virtual  you  you need Cisco UCS/Cisco UCS E-Series Platforms. Unity express 9 and 10 are EOS and the replacement will be unity connection. Unity connection can be installed on  Cisco UCS/Cisco UCS E-Series

So better make use of unity connection if you need to test voicemail as the setup you are trying is quite old method. 

 



Response Signature


View solution in original post