voice on 2801 with vic3-2fxs/did

[aleemuddin]

hi,

I am trying to configure voice on 2801 with vic3-2fxs/did while IOS is 12.4(20)T

dail tone is available but when i dial number dail tone is still cont...no ring tone

voice-port 0/0/0
input gain 7
cptone BR
timeouts call-disconnect 5
timeouts wait-release 5
!
voice-port 0/0/1
input gain 7
cptone BR
timeouts call-disconnect 5
timeouts wait-release 5
!
dial-peer voice 410 pots
destination-pattern 410
port 0/0/0
!
dial-peer voice 411 pots
destination-pattern 411
port 0/0/1
!

*****

same configuration worked for me using vic2-2fxs with IOS 12.4(15)T or etc.,, now cisco replaced vic2-2fxs with vic3-2fxs/did and it will work only on IOS 12.4(15)ZX or 12.4(20)T. after upgrading IOS router can  see the voice card and i configured ports ..dail tone there but when dailing on number dail tone is not changing to ring tone..

pls advise.. Thanks

[Steven Holl · Accepted solution]

That should be all you need to get this to work.  Collect:

debug voip ccapi inout

debug vpm sig

And for kicks, try it with input gain at 0.

[aleemuddin]

Hi Steven,

Thanks for your support man..Input gain 0 worked.. thanks again.

regards,