07-03-2018 02:04 AM - edited 03-18-2019 12:27 PM
Hello all,
I have a cisco ISR 4321 , i would configure E1 , but the port 0/1/0:15 not diplayed in gateway.
you can receive the config below.
can you help me please
Best regads
Akram
Solved! Go to Solution.
07-03-2018 05:00 AM
Hi,
can u try the command under controller E1and check.
pri-group timeslots 1-31 voice-dsp
regds,
aman
07-03-2018 02:46 AM - edited 07-03-2018 04:00 AM
Hi @akram.root
You have got this message on your sh run config @akram.root:
! card type command needed for slot/bay 0/1
Please @akram.root check the gw-isr4431-1.txt file that you have posted first.
Just above your enable password Didata2018 command you have:
! card type command needed for slot/bay 0/1
I don't see any controller e1 also.
Do you configure card type e1 command? And after configure the controller interface.
07-03-2018 03:09 AM
thank you for your reply ,
i not have this message on sh run
card type command needed for slot/bay 0/1
i configured card type e1 command and controller interface but d'ont work
07-03-2018 03:38 AM - edited 07-03-2018 03:41 AM
Hi Akram,
You have available PRI E1/T1 slot and I can see you have configured the e1 controller.
You need to create the pri-group under the controller.
Isdn switch-type primary-ni
Controller e1 0/1/0
pri-group timeslots 1-
Please refer the discussion :
https://supportforums.cisco.com/t5/ip-telephony/voice-ports-not-showing-up-on-isr-router/td-p/2053084
Regards
Prassha3
Rate if you find this helpful
07-03-2018 03:49 AM
thank you for your reply
I tested but not displayed voice-port 0/1/0:15
Best regards
07-03-2018 04:04 AM
I have configured
card type e1 0 1
best regrds
07-03-2018 04:05 AM
yes i configured e1 after i configured controller e1
best regards
07-03-2018 04:09 AM
07-03-2018 03:00 AM - edited 07-03-2018 03:01 AM
Hi Akram,
Let me know if you are able to set the card type and controller type. If not can you share the output for show controller and show inventory.
eg : card type e1 0:15
controller e1 0:15
You can refer the document for configurations :
Regards,
Prassha3
Rate if you find this helpful
07-03-2018 03:16 AM
07-03-2018 05:00 AM
Hi,
can u try the command under controller E1and check.
pri-group timeslots 1-31 voice-dsp
regds,
aman
07-03-2018 06:43 AM
yhank you very much
it is displayed now
thank you for your help
Best regards
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: