Voice Translation Profile question

[Lance Cutler]

     What is the order of operation on voice profiles?

I have a specific interest regarding an incoming profile on a dial peer and a voice port.

Which one is first and applied?

I want to test but do not have access at this time.

So if I have a profile that translates 8885551212 on a dial peer to 81212, I have another that translates to 71212 on the voice port.

If 8885551212 is dialed which profile has precidence.

thx

[Mohsin Khan Feroz]

Hi

Voice translation profiles (which reference voice translation rules) are referenced by the following:

• Trunk Group - Two different translation profiles can be defined in a trunk group in order to perform number translation for incoming and outgoing POTS calls. If an outgoing translation profile is defined in a trunk group, the number translation is done while the outgoing call is setup.
• Source IP Group - A translation profile can be defined in a source IP group in order to perform number translation for incoming VoIP calls.
• Dial Peer - Two different translation profiles can be defined in a dial peer in order to perform number translation for incoming and outgoing calls.
• Voice Port - The translation profile can be defined in a voice port in order to perform number translation for incoming and outgoing POTS calls. If a voice port is also a trunk group member, then the incoming translation profile of a voice port overrides the translation profile of a trunk group.
• Non-Facility Associated Signaling (NFAS) Interface - The translation profile can be defined for an NFAS interface through the translation-profile command line from the global voice service pots configuration in order to perform the number translation for incoming and outgoing NFAS calls. This translation profile has a higher precedence than the translation profile of a voice port and trunk group in case a channel also belongs to a voice port and/or trunk group with the translation profile defined.
• VoIP Incoming - The translation profile can be defined globally for all incoming VoIP (h323/sip) calls in order to perform number translation. If an incoming H.323/SIP call is associated with a Source IP Group with a translation profile defined, then the translation profile of the Source IP Group overrides the global translation profile for incoming VoIP calls.

Mohsin..

[Lance Cutler]

Looks like it takes the most specific match.

In example above it took the dial-peer match over the Voice-port.

Thanks for your help

[Mohsin Khan Feroz]

Please rate.. if that resolved ur Question..

Mohsin.