10-17-2014 04:53 PM - edited 03-17-2019 12:35 AM
Hi,
we have 2921 router connected with 4 pstn line. and router added to the cucm 8.5 using h.323
how can i map one pstn number 3424758xx to extension 2500 ?
i have mapped as below but when dial from outside to 3424758xx just ring no indication on 2500.
Foreign Exchange Office 0/1/0 Slot is 0, Sub-unit is 1, Port is 0
Type of VoicePort is FXO
Operation State is DORMANT
Administrative State is UP
No Interface Down Failure
Description is not set
Noise Regeneration is enabled
Non Linear Processing is enabled
voice-port 0/1/0
signal groundStart
connection plar opx 2500
dial-peer voice 1 voip
description VoIP Trunk to Cucm
destination-pattern [1-9]...
session target ipv4:172.25.25.16
incoming called-number .
voice-class codec 1
voice-class h323 1
dtmf-relay h245-alphanumeric
no vad
dial-peer voice 3 pots
incoming called-number .
direct-inward-dial
!
dial-peer voice 4 pots
incoming called-number .
port 0/1/0
Thanks,
12-03-2014 12:35 AM
Hi Frank,
1.) Is the number 2500 assigned to a phone/hunt-pilot?
2.) Do a debug voip dialpeer inout
12-15-2014 05:58 AM
Hi Zekeria,
2500 assigned to the phone.
no output for above debug command
Thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide