When trying an Ad hoc conference, all calls get disconected

[Augusto Garcia]

Hello

I'm having trouble with a CUCM server and Ad Hoc  conference, when I try to do a conference between 3 phones all 3 calls  get disconected. From what I understood, ad hoc must work without the  need of a conference bridge, so I'm not pretty sure on where to look at.

Can help on troubleshooting this?

Thanks a lot

Best regards

[Jaime Valencia · Accepted solution]

No, you're wrong. ad-hoc (or meet-me) conference DOES require a CFB, SW or HW.

With that in mind, take a look at your config and make sure you do have one configured and available.

HTH

java

if this helps, please rate

www.cisco.com/go/pdihelpdesk

[Augusto Garcia]

It was the configuration of the regions, we have 2 regions conected to the cucm by a switch and those have a software media resource gateway, I configured the comunication between these regions with g711 and is working perfectly.

For the other regions I will configure a hardware mrg in order to use g729