07-14-2011 09:05 AM - edited 03-16-2019 05:57 AM
Hi,
We experience some problem about IP-to IP Gateway.
We use Cisco 2811 ISR using MGCP, and SIP IP-IPGw.
The router have VWIC2-2FMT-E1 (in MGCP) and use HWIC-2FE
If we use the IOS c2800nm-advipservicesk9-mz.124-11.T2.bin then the HWIC-2FE is not supported
If we use c2800nm-advipservicesk9-mz.124-24.T2.bin then we have the bug %SYS-2-INPUTQ.
When we check the bug toolkit, then it ask to upgrade the IOS
When upgrading the IOS to c2800nm-advipservicesk9-mz.124-24.T5.bin (this is the last of the T version) then we have the bug %SIP-3-UNSUPPORTED.
And the Error decoder ask us to upgrade once again.
So which IOS support these features, and without these bug on cisco 2811
MGCP
IP-toIP GW (SIP)
HWIC-2FE
MFTE1
we already check the c2800nm-adventerprisek9_ivs_li-mz.124-24.T5.bin, but it doesn(t support MGCP.
Regards,
Antra
07-17-2011 05:29 AM
Hi Antra,
Your current IOS version supports all the features you looking for,
HWIC-2FE Support on 2811
MFT-E1
MGCP and SIP Support (Cisco Feature Navigator),
http://tools.cisco.com/ITDIT/CFN/Dispatch?act=rlsSelect&task=search&searchby=software
With respect to "%SIP-3-UNSUPPORTED" error, you typically see this message when you run unsupported features like DO-DO Video call, unsupported payload / packatization, etc.
It is difficult to say anything without the complete error message or the Bug-ID. Could you please copy the complete error message or the Bug-ID ?
Regards,
Vinay
07-17-2011 12:08 PM
You can use, for example, 15.0(1)M6.
02-28-2012 04:25 AM
Hi,
The problem was not a bug but the ptime value.
The ptime value should between 5 to 20 but the ptime value in the other side is more than supported by cisco.
regards,
Antra
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: