cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1296
Views
10
Helpful
3
Replies

which IOS resolve this %SIP-3-UNSUPPORTED and %SYS-INPUTQ

iantra123
Participant
Participant

Hi,

We experience some problem about IP-to IP Gateway.

We use Cisco 2811 ISR using MGCP, and SIP IP-IPGw.

The router have VWIC2-2FMT-E1 (in MGCP) and use HWIC-2FE

If we use the IOS c2800nm-advipservicesk9-mz.124-11.T2.bin then the HWIC-2FE is not supported

If we use c2800nm-advipservicesk9-mz.124-24.T2.bin then we have the bug %SYS-2-INPUTQ.

When we check the bug toolkit, then it ask to upgrade the IOS

When upgrading the IOS to c2800nm-advipservicesk9-mz.124-24.T5.bin (this is the last of the T version) then we have the  bug %SIP-3-UNSUPPORTED.

And the Error decoder ask us to upgrade once again.

So which IOS support these features, and without these bug on cisco 2811

MGCP

IP-toIP GW (SIP)

HWIC-2FE

MFTE1

we already check the c2800nm-adventerprisek9_ivs_li-mz.124-24.T5.bin, but it doesn(t support MGCP.

Regards,

Antra

3 Replies 3

Vinay Kumar Dharmaraj
Cisco Employee
Cisco Employee

Hi Antra,

Your current IOS version supports all the features you looking for,

HWIC-2FE Support on 2811

http://www.cisco.com/en/US/prod/collateral/routers/ps5854/product_data_sheet0900aecd80581fe6_ps5855_Products_Data_Sheet.html

MFT-E1

http://www.cisco.com/en/US/prod/collateral/routers/ps274/product_data_sheet09186a0080091b9c_ps259_Products_Data_Sheet.html

MGCP and SIP Support (Cisco Feature Navigator),

http://tools.cisco.com/ITDIT/CFN/Dispatch?act=rlsSelect&task=search&searchby=software

With respect to "%SIP-3-UNSUPPORTED" error, you typically see this message when you run unsupported features like DO-DO Video call, unsupported payload / packatization, etc.

It is difficult to say anything without the complete error message or the Bug-ID. Could you please copy the complete error message or the Bug-ID ?

Regards,

Vinay

paolo bevilacqua
Hall of Fame Master Hall of Fame Master
Hall of Fame Master

You can use, for example, 15.0(1)M6.

Hi,

The problem was not a bug but the ptime value.

The ptime value should between 5 to 20 but the ptime value in the other side is more than supported by cisco.

regards,

Antra

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: